Repsol Hidroleo 68

Description
Maximum quality oils for hydraulic circuits. Made with top quality paraffin base crude oils, refined using solvents and hydro finished endowing them with excellent oxidation resistance and a high viscosity index. The additives used in the elaboration are of the “ash free” type.
Recommended uses
As it is an hydraulic oil with anti-wear additives of the ash-free type, it is recommended for use in severe service and in conditions with highly demanding filterability: servo-valves, robotics, numeric control systems, etc. In hydraulic engines which work with heavy loads (in terms of pressure and temperature). When high variations in the range of temperatures are at work.
Qualities
Excellent anti-wear properties, EP (F.Z.G.)
Low freezing point facilitating good pumping at low temperatures.
Advanced anti-rust and anti-corrosion capacity. Does not affect copper or its alloys.
Very good water separation properties (demulsibility).
Resistance to foam formation and high de-aeration facilities.
Advanced rust protection. Excellent thermal stability.
Exceptional filterability.
Excellent protection of joints and elastomers.
Quality Level
DIN-51524 Part 3 HVLP
AFNOR NFE 48603 HV
DENISON HF-0, HF-1 y HF-2
CINCINNATI MILACRON P-68, P-69, P-70
SPERRY VICKERS
SAUER-SUNDSTRAND
VOITH
Technical Data

Available in
Bulk: All ISO Grades
185 Kg. drums : ISO grades 32, 46, 68 and 100
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes.

Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Do not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets.
Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.

Unless otherwise specified, the values cited in technical characteristics should be considered as typical.